burghardt/easy-wg-quick

Following command will create wgclient_client_name.conf file.On hub configure Wireguard.On peer scan QR code or copy wgclient_10.conf. To display QR code again useFinally on hub check if everything works with sudo wg show.By default easy-wg-quick use interface with default routing done over it as set interface name in extnetif.txt file with command:By default easy-wg-quick uses IP address of interface that has default file with command:By default easy-wg-quick use randomly generated internal network addresses and intnet6mask.txt (IPv6).By default easy-wg-quick uses 1.1.1.1 as it's internal DNS. command below to serve a custom IPv4 DNS to clients.By default easy-wg-quick uses 2606:4700:4700::1111 as it's internal DNS. named forceipv6.txt can forcibly enable IPv6 support.To use outer IPv6 addresses (i.e. connect client to hub over IPv6) just set name and IPv6 address (or edit wghub.conf).By default easy-wg-quick uses IPv6 masquerading to provide IPv6 connectivity Wireguard interface (i.e. 2001:19f0:6c01:1c0d:40/112).Please note that NDP proxy mode in easy-wg-quick is supported only on Linux.DNS redirection might be required to integrate with services like Pi-hole or